If youre having light leaking from the side of your goggles, heres a fix for you.    Cut some 10mm thick foam as shown and slide into the sides,   you can even use the foam from the packaging of the goggles to make it.

Ive included some shots and a DXF file if you want to laser cut your own or you could just use scissors as it wont be seen when fitted.

Good Idea Thanks

zappy49@gmail.com Posted at 5-6 05:34
Good Idea Thanks

You’re very welcome.

Excellent DIY fix for side light leak.  

Interesting solution. I've seen a few people wobble the rubber a bit after putting Goggles 3 on their face and they say that fixes the light leaks, did you maybe try that?

fichek Posted at 5-6 16:50
Interesting solution. I've seen a few people wobble the rubber a bit after putting Goggles 3 on their face and they say that fixes the light leaks, did you maybe try that?

Yes I tries all sorts with the rubber but I still got very subtle light leaking from one side,   

DowntownRDB Posted at 5-6 14:09
Excellent DIY fix for side light leak.

Cheers DT,  Its surprising how well this foam cuts with my laser too.

Mine came with the foam which I jut cut down to fit inside the rubber curtain to afford further protecion. Any light leakage fixed by doing what fichek advises.

yogi053 Posted at 5-7 02:07
Mine came with the foam which I jut cut down to fit inside the rubber curtain to afford further protecion. Any light leakage fixed by doing what fichek advises.

I must have a slightly deformed head then.

DAFlys Posted at 5-6 21:40
Cheers DT,  Its surprising how well this foam cuts with my laser too.

No doubt that made the DIY fix easy for you to do.  

Great idea Daflys .. thanks for sharing the cad file

MAF178 Posted at 5-7 14:11
Great idea Daflys .. thanks for sharing the cad file

No probs MAF178.  

DowntownRDB Posted at 5-7 13:46
No doubt that made the DIY fix easy for you to do.

I must confess to cheating a little on this one,   to get the right curve I traced around the rubber and then scanner in the drawing and traced the cad over the top.  

DAFlys Posted at 5-7 22:35
I must confess to cheating a little on this one,   to get the right curve I traced around the rubber and then scanner in the drawing and traced the cad over the top.

That's not cheating, that's just working smarter.  

DowntownRDB Posted at 5-8 02:42
That's not cheating, that's just working smarter.

Its actually a bit of an odd curve more of an ellipse thats been cut than a arc.

What about light bleed from the top when using the extended forehead pad? it is horrible and gets so bright

IxToxicity Posted at 5-11 12:48
What about light bleed from the top when using the extended forehead pad? it is horrible and gets so bright

Ive not tried the pad,   didnt feel I needed it personally.