JKD
New
United Kingdom
Offline
|
Hello!
I have a brand new P3S, not even started up the motors yet!
Yesterday, despite the miserable weather here in the UK, I decided to get her set up and ready for a flight.
What I did;
- Charged up the batteries.
- Made a DJI account.
- Switched on the RC, the quad and booted up the app.
- Followed app instructions and activated quad with serial number.
- Downloaded latest firmware update 'P3 Standard 1.3.50' through the app.
- Started firmware update process.
- There was a lot of constant beeping from the quad and no movement on the update for a significant amount of time.
- I gave up on the update, and powered everything down.
- Now my quad can't read an SD card (even the original one that started the firmware update).
- The gimbal seems to lose power and suddenly goes limp after the boot up dance has completed.
What I have tried to fix it;
- 3 different SD cards, one of which is brand new and went straight into the quad (image of these cards below).
- Formatting the SD cards with this tool - https://www.sdcard.org/downloads/formatter_4/
- Formatting the cards in app (image of error below).
- TRAWLED the forums for potential solutions, most of which seemed to point to bad SD.
How can I fix this? :-(
UPDATE: I found the micro usb port on the upper part of the gimbal so plugged it into my PC. The contents of the freshly formatted original 8GB SD card poppup up as removable storage (it kept disconnecting and reconnecting which seemed odd). In the contents I found the error logs, which read;
[00003420][01 00] Firmware upgrade finished failed (step = 3, err = 0xffffffff).
[00000855][01 00] Firmware upgrade finished failed (step = 3, err = 0xffffffff).
|
|