Hello,

I received two A3 and decided to put one on a Gyrphon dynamics frame with T-motor U10 motors and Hobbywing Platinium Pro 60A ESC (with Futaba S-Bus receiver). But I have a problem, the A3 doesn't recognize the ESC. When I tried with 80A Flame from T-motor, it failed too but with T-motor 40A (AIR40A 600Hz and 40A Pro 400Hz) it's working. I don't understand why, does anyone has an idea ?

Thanks

While the A3 is able to work with most 3rd party ESCs, it's not compatible with all of them. Unless there are any tweaks that you can do to your ESCs using their software, you may need to move to different ESCs.

Dear Jamie
Trying to use Hobbywing ESC 80A 5s-12s with A3  , could you pls confirm whether they are compatible ?  and how calibrate ESCs with A3 ?

I use this hobbywing XRotor PRO 50A and they work if you can use it for something I do not know
I use them on tiger u5 on a gryphon x8

ckk.post Posted at 2016-11-6 23:52
I use this hobbywing XRotor PRO 50A and they work if you can use it for something I do not know
I us ...

i am also going to use with Gryphone frame  ,
ESC80 5s-12s with 30" props
how did you calibrate ESCs ? using assistant ?

dani2013 Posted at 2016-11-7 09:32
i am also going to use with Gryphone frame  ,
ESC80 5s-12s with 30" props
how did you calibrate  ...

No. I use Futaba and calibrated them before I mounted them with Futaba receiver

I have issue with ESC too !!

we are uav builder and built lot of uav with DJI FC

last survey uav work fine with A2 and littlebee 30A on 6s and tmotor 4004
ESC are flashed with blheli 14.6 , fantastic flight and never issue

now we build the same frame with DJI A3 and littlebee 30A-S
blheli-S is not compatible with A3
A3 broke all of 8 ESC
i reflashed ESC but they are out , impossible to turn motor
i replace ESC by old littlebee 30A and all worded fine yesterday without propp
today i place propp on motor and go outside to test uav , but only one and few seconde later one other motor start
strange !!... i come bach home to check and 6 ESC are burned
i connect ESC on F3 racing FC to setup blheli and only one ESC is reconized by blheli soft , 7 ESC not reconized , but on motor test , 2 motors start

i need a solution to found ESC compatible with A3 , small size and 6s 17A max from motor