My dji 3 says no signal, this was right after I updated the firmware on it. I used it right before then and it was fine.
How can I fix this?

Thanks for you time

Just finished with this problem, in my case I did a Nono. I updated the controller first then the aircraft. Must do the aircraft first or you get the signal lost message,

Billbo Posted at 2016-11-27 17:12
Just finished with this problem, in my case I did a Nono. I updated the controller first then the ai ...

I believe I have done the same thing.What are the steps to take to fix this now?


Thank you.

Billbo Posted at 2016-11-28 06:12
Just finished with this problem, in my case I did a Nono. I updated the controller first then the ai ...

Which phantom do you have. You might try to put the bin file on your sd-card and put it in the phantom. It should update ok. Be patient. You may have to re-link the RC with the copter also. If you are successful, check that the versions are correctly showing in your app.

Thank you. All I had to do was relink it. It's now working perfectly!

Joey125 Posted at 2016-11-28 09:30
Thank you. All I had to do was relink it. It's now working perfectly!

Glad to hear that you figure it out.
Enjoy your flight. :-)