Hello guys,

after I flew with smaller copters with the Naza controller in the last years, I bought me a S900 with a A2 controller and iOSD M2.
In the last days I got the Zenmuse Z15 GH3 and Lightbridge components for dual video/ dual remote.

After I connected all cables of the A2 and iOSD I had problems to connect the Lightbridge and the Z15 correctly with the other components.

I connected the cable in the following way:
- A2:
  - CAN1 -> IMU/ GPS
  - CAN2 -> PMU/ LED
  - X1 -> PMU
  - X2 -> Lightbridge (DBUS)

- Lightbridge:


But I connected the CAN-Bus and AV cable of the Zenmuse with the iOSD.

Is my wiring correct for dual control and dual remote?
I want to controll the copter and the gimbal over one Lightbridge air system and two ground stations. Not with a 5,8ghz receiver, as you see in the picture.

Thank you for your help!

Regards from Germany
Wolfgang

Hello guys,

after I flew with smaller copters with the Naza controller in the last years, I bought me a S900 with a A2 controller and iOSD M2.
In the last days I got the Zenmuse Z15 GH3 and Lightbridge components for dual video/ dual remote.

After I connected all cables of the A2 and iOSD I had problems to connect the Lightbridge and the Z15 correctly with the other components.

I connected the cable in the following way:
- A2:
  - CAN1 -> IMU/ GPS
  - CAN2 -> PMU/ LED
  - X1 -> PMU
  - X2 -> Lightbridge (DBUS)

- Lightbridge:


But I connected the CAN-Bus and AV cable of the Zenmuse with the iOSD.

Is my wiring correct for dual control and dual remote?
I want to controll the copter and the gimbal over one Lightbridge air system and two ground stations. Not with a 5,8ghz receiver, as you see in the picture.

Thank you for your help!

Regards from Germany
Wolfgang