Hello everyone.  I recently updated my firmware to: Aircraft - 1.10.01.40, Controller - 1.7.60, App - 3.1.5.  Since then every time I power up I get a continuous warning beep from the controller until I calibrate the sticks.  Problem is when I move the sticks as instructed, the "Finish" link never lights up and the % indicator in the middle of the calibration bar never changes.  I then have to escape out of the calibration page and everything seems normal.  I have had a few instances when the motors seem to want to overpower without controller inputs so this is a little worrying.  Any thoughts please?  Thanks John  

Did you rotate the gimbal dial as well?
Have you tried to reinstall the DJI GO app?

DJI Mindy Posted at 2017-3-9 03:48
Did you rotate the gimbal dial as well?
Have you tried to reinstall the DJI GO app?

That's fixed it Mindy, thanks very much.

fans80ebcccd Posted at 2017-3-9 12:00
That's fixed it Mindy, thanks very much.

No problem. Have a nice day. :-)