ombravo
New
Ecuador
Offline
|
Hi Elektra, I have a phantom 3 advanced:
Aircraft Model: W322 - Firmware: 1.11.20
RC Model: GL300A - Firmware: 1.9.2
DJI GO app: 3.1.18
When I first turned on the aircraft and rc since like 4 months ago (I kept it inside a case everything normal and untouched) the DJI Go app connects to the rc with no problem, the rc shows the green light but the app shows "no image transmission signal" for like 5 seconds and then "disconnected", then again the app looks like trying to connect but same message and disconnect on and on, the status shows the Deserializer Disconnected - Hardware malfunction message also.
After that I updated the aircraft to the last firmware with no problem, but the app at some time displayed that the rc needs upgrade to 1.9.3 and when I try upgrading from the phone it gets stucked at 89% after 2 minutes
I already tried turning on aircraft, rc and app in different order, I even used an old ipad air which had an older version of dji go but with the exact same behaviour, re linked the rc and aircraft but nothing.
The rc connects correctly the to aircraft according to its green light, i can even move the camera, but the app shows the same messaging connecting and disconnecting every 5 seconds.
Thank you very much for your help |
|