When I'm controling the aircraft, when I take picture or videos stays just like that. I ALREADY calibrated the gimbal.
But when I put point of interest the picture stays normal. What I have to do? Can I control the camera to the sides?

I get that on occasions. Depends on the wind and how hard you are turning. Also check you don't have FPV mode on.

StephenGSY Posted at 2017-4-19 15:57
I get that on occasions. Depends on the wind and how hard you are turning. Also check you don't have FPV mode on.

it is follow mode, even with low wind. But even when the aircraft is off the camera doens't stays straight. I will try to slow how hard the aircraft goes, thanks!

If you make a rapidly turn the gimbal tries to make the camera rotation smoother and you got the leg in front of lens. Make the turn wider and slower,so the gimbal has time to react better.

Does this happen even if the drone is hovering still?

fivetonine Posted at 2017-4-20 03:47
Does this happen even if the drone is hovering still?

yes, it happen when the aircraft is hovering still

César Ferrari Posted at 2017-4-20 10:46
yes, it happen when the aircraft is hovering still

So just so I'm on the same page, the camera will start off straight and then move over time?

I have a very similar problem, although not that extreme. My camera regardless of what I do is not straight. I performed an IMU calibration, then a gimbal calibration and it does not center, it always points to the right. This all started right after I experienced a camera motor overload. I researched the overload on line and found where the set screw on the main motor shaft loosens up and needs to be re tightened. I tightened up the set screw and that issue is resolved but now the camera is not centered.

I just received this for my birthday on the 31st of March. Very annoying to say the least.