Seems a little odd...

M600 Pro A3 just out of the box and latest DJI Assistant 2 (1.0.9.2).
M600 and Lightbridge 2 show up as connected devices but no A3.

USB cable connect just under LED on M600.
Am I missing something?

Hi,
M600 will not show A3 as the M600 is the A3 interface.. Under m600 you can change gps antenna and imu location, look at esc, and a few other but not the level as if you were running an independent A3

hope that helps

Ricci

ricci2 Posted at 2017-4-26 16:45
Hi,
M600 will not show A3 as the M600 is the A3 interface.. Under m600 you can change gps antenna and imu location, look at esc, and a few other but not the level as if you were running an independent A3

Hey Ricci2,

So your saying I can't do anything like RTH minimum attitude, failsafe, gain adjustment, etc.?

rick.iseeit Posted at 2017-4-26 17:49
Hey Ricci2,

So your saying I can't do anything like RTH minimum attitude, failsafe, gain adjustment, etc.?

Call dji support for downgrade and then update only dji support resolve this problem

rick.iseeit Posted at 2017-4-26 17:49
Hey Ricci2,

So your saying I can't do anything like RTH minimum attitude, failsafe, gain adjustment, etc.?

You can do the mentioned adjustments via the DJI Go app

rick.iseeit Posted at 2017-4-26 17:49
Hey Ricci2,

So your saying I can't do anything like RTH minimum attitude, failsafe, gain adjustment, etc.?

Hi,
As Nil said all adjustments are in one convent place on the Go app now, which makes sense unless you want to have a computer nearby, plug in cables, ect,ect.
There is not the integration as with the independent A3 but unless you have very special requirements all is catered for on the app. Dji assume they have given you the best setup and only allow you to do refinement tweaks on the app and I have to say except when they have firmware glitches it has worked fine for me for nearly a year.

ricci