Hi,

Just got my Mavic Pro - first drone and enjoying every minute of learning.
One problem. I cannot start the motors with the RC. Have to take off using DJI Go App.
I have disabled beginner mode, and have strong GPS signal.
Can anybody tell me what I am doing wrong?

Thanks

Assuming you are doing the CSC command to try and start ?
You could check the remote calibration to see that both sticks move fully.
Apart from that its hard to say without more details of what you are doing.
Good luck...

Just move the sticks on the remote control as shown in the picture.

Mcflying Posted at 2017-5-26 03:31
Just move the sticks on the remote control as shown in the picture.

Thanks. Yes, that is what I am doing, but not a peep out of the motors, although they start up just fine when using automatic lift-off in the app.

Check the stick calibration.  My Mavic arrived with bad calibration.  Using the Take Off button it would hover properly but only go down and to the right.