DJI Elektra
DJI Team
Hong Kong
Offline
|
canistraccioil Posted at 2017-9-1 01:13
I did some further testing over this subject, and I found that the situation is much more complicated than expected.
When CrystalSky is connected to the Remote Controller with GPS turned off, the embedded DJI GO 4 app acquire the GPS data coming from the external GPS Module for Remote Control (you may see the blue dot on the map), but somehow the DJI GO 4 app can't use these information to set the home point to Remote Control position: it says the GPS signal is weak and position cannot be recorded (but it's not true, the signal is strong and position is fixed, you may see on the map on the left bottom on the screen).
So I removed the GPS Module for remote control and enabled the GPS on CrystalSky.
Did you open the selection of dynamic home point?
Please enter the attached interface and slip to the left. Make sure that all the setting is done. |
|