Hi everyone,

today i was using my drone and immediatly after the take off i had an error "gimbal shaking error" the video was very shaky, never crashed the drone .

i tried to recalibrate the gimbal with no error, but when i tryied again same error.. gimbal shaking error..

how can i fix it?

thank you

Are you using the original props or the low-noise ones? I know that when I installed the low-noise ones, I would get the gimbal shaking error. I immediately landed the Mavic Pro and realized that the props did not fully extend. I went ahead and fully extended them and gimbal shaking went away.

Hi Relaxz, could you please provide a screenshot of the error message for better assistance? What is the current firmware version of your drone?

Check to make sure the gimbal is seated correctly underneath the tabs front and back.