Need help setting up a naza lite with a spektrum dx6 with ar610 receiver.
I cant get it to work. I connect everything and after the leds blink normally, then it starts blinking red...
Tryed everything but nothing works. Any advice or checkup list?
DJI-Tenna Posted at 2014-11-6 19:58
Hi Sir, when you connect to software, do the channels respond you toggling the switches?
Please show ...
I ma having simimlar issues, I plug it into the computer . software and it seems stuck in failsafe. If I plug U into aux, it's stuck in failsafe and seems to only recognise one switch, but it nevers leaves failsafe.
I plug it into aux 1 on hte naza into the gear and it goes to atti flight mode, I can start the drone up with that but cannot launch off the ground.
lvl.1
lvl.2
New
lvl.3
