BigDave110
lvl.2
United States
Offline
|
DJI Mindy Posted at 4-9 22:56
Hi there, may I ask if you've tried to connect the RC 2 to WiFi or hotspot and power on the drone for a check? Please also update the firmware to the latest version.
Yes, I am on the latest version.
It appears that if the drone and controller are connected and powered, the map of my local area appears. However, if I power the RC2 alone, it displays a location in Beijing and says it cannot obtain current location. I am indoors at the moment with no GPS lock.
I have not tried every possible combination of powering sequence, but after power cycling the controller I am now seeing the world map. This may be all expected behavior. However, I would think that given no GPS input, the last known location would be remembered until either GPS is obtained or a manual location was selected.
I just discovered a new firmware version is available, so I will reload and try again.
It seems that my location should be roughly determined by either my last known or WIFI network location.
|
|