I am planning to mount two different cameras on M600 Pro and below is the setting that I am thinking of:
Platform: DJI M600 Pro
Camera/Gimbal 1: DJI Xenmuse X5 + DJI M600 series Xenmuse mount
Camera/Gimbal 2: FLIR Vue Pro + Gremsy S1 Gimbal
Control: M600 series remote controller + channel expansion kit
Question 1: I'll probably connect X5 to Lightbridge 2. Then, what other video transmission system can I use for the Vue pro? And how would I take care of the power?
Question 2: So I am trying to set two gimbals (Xenmuse S5 and Gremsy S1). And I want to control both gimbals on a single M600 series remote controller by adding the channel expansion kit. I was not able to find any good video on how this can be done from wire connection to channel settings. Have anyone done this or a similar thing before?
Much thanks!
P.S. some people might ask me why don't just buy FLIR Duo. Totally, but I just want to use my old Xenmuse X5 instead of buying a new camera.
You need put one of them with another Lighbridge 2, with second cameraman.One camera gimbal in front and another in the middle, both in the below support rods.
In short, two cameras, two gimbals, two TX and two RC.
it can be done I do believe. there is wa way to take the PMW of the A3/LB to run the gimbal, as for video feed it would be the FPV input only. i am doing the same setup with my M600s XTPRO 640x51230HX19MM With X5R with zoom.
lvl.2
lvl.4
