Hi
I have Updated the SW (LATEST FIRMWARE V01.01.0100 )brand new received mini pro 3 today. After pairing /binding process completed I see front legs LEDs blinking red. Also Go fly cannot switch to Camera view.
Any idea?
I have tried my second RC (I had to sent my previous mini pro 3 to service due to gimbal stuck problem so i had another RC controller.)Not working also.

Also After binding previous RC to new drone, I had 2 x Mini pro 3 device on my device management page. So is it ok to have same named drones added on device management BUT unlinked at least one of them ,while using other one?

Thanks
BR

what is the pattern of flashing, can you post a vid?

fateofangel Posted at 7-17 16:37
what is the pattern of flashing, can you post a vid?

i can do later. Briefly; front legs blinking simultaneously red around every 0.5 Sec.
I have downgraded the RC software and  Front LEDs started to blink normally BUT still cannot switch to GO FLY /camera view.

FYI: Already refreshed the both Firmware on both RC and Mini pro.

After dji support refreshing the both RC and Drone firmware still no idea why cannot go int o camera view..