jclarkw
lvl.4
United States
Offline
|
I have an RC231 (which I'm advised is similar to the RC-N1) that came with the Mavic Air 2 "Fly More" package. It's still on a Dec, 2020, firmware version, and I'm trying to update that using DJI Assistant 2. After updating Assistant 2 itself (the first roadblock), I can now connect my PC to the RC, but Assistant still doesn't obtain the firmware list from DJI.
The solution proposed by DJI Gamora in an earlier thread was to connect my computer to a cell-phone hot spot (presumably to circumvent my router), but that's not possible here because of no cell service. I have solid Internet, but only by wired Ethernet through a router that is, in turn, connected to a microwave transceiver on the roof provided by a local ISP.
So my question is this: Can anybody tell me what is the likely roadblock caused by my router and/or my PC firewall so that I can remove it, at least temporarily?
If it's the router, I could bypass it and connect the PC directly to the microwave transceiver. If it's my firewall, I can tweak settings accordingly, but trial-and-error is unproductive. Can anybody help? -- jclarkw
|
|