Hi,

My dji mavic 2 pro recently had a hard landing. needed to do some clean up on gimble. after reassembling everything, it asks to recalibrate the vision system using DJI Assistant.
I've installed the DKI Assistant 2 (Conseumer Drones Series) v2.1.13 on a MacAir M2 with OSX 13.5.1
Once installed software can detect and connect to drone fine.

However I then have 2 issues

• when I start the calibration, it doesn't show the red box when I point the drone to the screen (but it shows that the cameras ca see the pattern).
• it fails to get the log list from the log export
  

Any clue what these 2 issues could be?

Hi there. Thank you for reaching out and we're sorry for the incident that happened to your unit. You may consider sending the unit in for a proper diagnosis. You can contact our support team to start up a ticket at https://www.dji.com/support . Thank you for your understanding and support.