Hi,

I tried to duplicate the screen of my M300RTK Smart Controller on a PC screen using the HDMI plug on the top of the RC.

For a fraction of second the RC screen is perfectly duplicated on the PC, but suddendly the duplicated screen changes and it shows the FPV camera video only. Enven changing the RC view to the Map of the Paylod Camera, the FPV camera live view is shown only.

I explored without success the Android HDMI settings.

Do you have any suggestion to get on the PC an exact duplicate of the actual RC screen using the HDMI port?

My firmware setup is as follows:
(PILOT 2) App: 7.0.1.1
Aircraft Version: 07.00.0100
Remote Controller: 07.00.0101
System Version 07.00.0100


Thank you in advance for your help,

Maurizio

Hello, there. Sorry for the inconvenience.
In firmware V7, the Video Output Type can be selected as “Duplicate Screen” and “Camera View” on the Image Transmission Settings page.
When “Duplicate Screen” is selected, the HDMI output device and the remote controller display the same screen.
Would you please confirm the settings?
If the settings are right, please record a video about the issue.