hi folks any help with this appreciated
cant get spinners on t40  going and comes up with low voltage and esc issues, any help appreciated

Hi there, we will need to confirm this with the corresponding team, we will keep you updated.

Any advice on this issue as I have the same

djiuser_od0kEHfWEqvD Posted at 3-6 08:56
Any advice on this issue as I have the same

Hi there, may I confirm if your product is also Agras t40 and has the same error messages?

Hi there, please try the suggestions  below to see if it works:
1. Restart the aircraft and see if the error recurs. If it does not appear again, you can use it normally
2. Check the centrifugal motor to see if it is stuck (foreign matter is stuck, the spinner plate is worn, etc.). If so, please clean or replace it in time;
3. Replace the centrifugal motor;
4. Replace the ESC cable.

DJI Mindy Posted at 3-8 04:17
Hi there, please try the suggestions  below to see if it works:
1. Restart the aircraft and see if the error recurs. If it does not appear again, you can use it normally
2. Check the centrifugal motor to see if it is stuck (foreign matter is stuck, the spinner plate is worn, etc.). If so, please clean or replace it in time;

What if none of these fixes work? I have the same issue and centerfugal motors and esc cable are all good.

gavin bunger Posted at 8-22 11:40
What if none of these fixes work? I have the same issue and centerfugal motors and esc cable are all good.

Hello, you can check according to the following steps:
1. Check whether there is wear and burning at the centrifugal nozzle disk and the lower cover of the motor;
2. Check the connection of the wires (connector of the composite wire of the machine arm on the power distribution board, adapter wire of the centrifugal nozzle at the end of the machine arm
3. If the above is normal, cross-check the centrifugal nozzle. If the broken centrifugal nozzle still reports an error in another position, it is recommended to replace the centrifugal nozzle motor. If it is always damaged on one side, it is recommended to replace the power distribution board and the wires in the machine arm for troubleshooting.
Note: If the spraying is turned on, and the two nozzles do not discharge water after the remote control turns on the spraying, and the speed is also 0, please check whether the spraying system is turned off in the spraying system settings of the remote control. If so, please turn it on and test again.

DJI Susan Posted at 8-22 23:51
Hello, you can check according to the following steps:
1. Check whether there is wear and burning at the centrifugal nozzle disk and the lower cover of the motor;
2. Check the connection of the wires (connector of the composite wire of the machine arm on the power distribution board, adapter wire of the centrifugal nozzle at the end of the machine arm

Thank you for the help, I swapped out the power distribution board for one of our other t40s and still the same issue, is there any other fix before I buy new nozzles, centrifugal motor, and wiring? The drone had the problem intermittently and would only have the issue randomly before it finally quit, so I’m hoping it’s something else.

gavin bunger Posted at 8-23 17:00
Thank you for the help, I swapped out the power distribution board for one of our other t40s and still the same issue, is there any other fix before I buy new nozzles, centrifugal motor, and wiring? The drone had the problem intermittently and would only have the issue randomly before it finally quit, so I’m hoping it’s something else.

Hello. Please provide us with basic logs and screenshots of error messages for further analysis. Thank you.