Help!
I have  had my DJI 3 pro for only 2 days. had its maiden flight yesterday in the garden and was all fine.

took it to the beach today to capture something a little more scenic. within minites I had a gimbal overload warning and the gimbal would not move from its position.

after a frustrating hour of just flying about I return home to investigate. I have watched about a hundred videos on youtube trying to remove the error. all of a sudden the error went and the gimble straighened up.

but now the gimble wll not tilt properly. it will either not do anything at all when I move the wheel or be really juddery, no smooth action at all.

any ideas?

I am pretty gutted as this is only the second time I have used it.

Did you take out the piece of white foam from behind the gimbal?

Check the setting in the app also - make sure it's not in FPV mode.

App settings all seem right how does sending it back for repair work?

when it get stucks it makes a very quiet click noise if that helps?