Hi there.  After an unknow reason, my drone crash. 100ft from the air.  I had to replace a motor, a ESC, and the plastic.

Now that everything is back in place, i had a defective compass ( i tought ) ..   Order a new one, replace it, and still have the x,y,z Value = 0
and the message that there is an abnormal problem with compass when i turn the Windows program on.

I decide to order a second one.. just in case.  ( Same problem Again. )

I then decided to order the Main control unit.  The new one dosn'T have the vision+ filter section ( Some caps and coil section )   but i'll try it to see what's going on.


Any other idea before i procede ?  (   I already try the Advanced cali .. ) without success.

Hi there.  After an unknow reason, my drone crash. 100ft from the air.  I had to replace a motor, a ESC, and the plastic.

Now that everything is back in place, i had a defective compass ( i tought ) ..   Order a new one, replace it, and still have the x,y,z Value = 0
and the message that there is an abnormal problem with compass when i turn the Windows program on.

I decide to order a second one.. just in case.  ( Same problem Again. )

I then decided to order the Main control unit.  The new one dosn'T have the vision+ filter section ( Some caps and coil section )   but i'll try it to see what's going on.


Any other idea before i procede ?  (   I already try the Advanced cali .. ) without success.