Hello,

I was trying to update my Naza V2 firmware to 4.06 and keep having a strange issue. The assistant software everytime shows it installing up to 100% then it says the upgrade failed. When I power cycle the device, it shows in the assistant software that it is now on firmware 4.06. I keep trying to reinstall 4.06 but it shows error after it reaches 100% every time. Is it safe to assume that it has taken 4.06 ok and just the assistant software is not working properly? Or should I keep trying to install 4.06?

Any help for this situation?

Hello!
Could you please send us the picture of the error and the firmware version?

I'm getting the same error - 4.06 downloads and installs to 100% then says it failed and to power cycle and try again - however the assistant is now showing 4.06 as the current code level.

I'm getting the same error - 4.06 downloads and installs to 100% then says it failed and to power cycle and try again - however the assistant is now showing 4.06 as the current code level.

Same situation here!
Seems to actually be working though I need to charge batteries and give it an actual test.

FugiTive Posted at 2016-5-20 03:09
I'm getting the same error - 4.06 downloads and installs to 100% then says it failed and to power cy ...

This may just be a temporary server error, however, please let us know if you run into any issues.