Hello , I'm newbie on the subject, already searched all manuals but I can not desifrar the problem.behold, when I try to run naza -M V2 assistant nothing happens , and it does not recognize any change is permanent. When updated the firmware rc he just moved to D -Bus and can not change, why the phantom assitent does not allow the naza assistent does not recognize. Could anyone help me ?Many thanks.

If you have a Phantom 2, then you need the PT2 assistant and the RC assistant.
The manual explains the procedure and you can find the assistants to download from this website under your model.

johnwarr.email Posted at 2015-1-27 06:32
If you have a Phantom 2, then you need the PT2 assistant and the RC assistant.
The manual explains t ...

I know that, i did all of it, all installed, conected, and on.
I do not change the receiver to the pcm mode instead.

brunoclelis.ema Posted at 2015-1-27 06:48
I know that, i did all of it, all installed, conected, and on.
I do not change the receiver to the ...

The Naza-m V2 assistant is not the correct software for the Phantom you need the PT2 and RC assistant as stated above.

all set up and ready to fly, thanks anyway guys.

brunoclelis.ema Posted at 2015-1-30 10:44
all set up and ready to fly, thanks anyway guys.

Did you download the DJI WIN Driver Installer?
And you need to be sure to hit enter when you enter your values in the boxes and watch that they change..