Hi all,

yesterday suddenly I had a problem with the tilt axis of my Ronin MX. There were loud vibrations and the engine became extremely hot.  Then I used the functions "Calibrate System" and "Auto Tune Stability" in the DJI Assistan  to solve the problem, but no result. Then I  made a firmware upgrade (CGU, IMU). Now the Gimbal is completely out of control and turns in all directions. I have to hold it to avoid damage. The setup was the same as always. Same camera, well balanced, the problem came without warning from one day to the other.

Any ideas ;-)?
Thanks Richard

Same here. Lmk if you find an issue.

kriegs Posted at 2017-3-14 06:44
Same here. Lmk if you find an issue.

I sent it to DJI :-)

And we have this problem

fans3ff297e6 Posted at 2017-5-11 11:57
And we have this problem

Could you clarify what troubleshooting you've done thus far to try and rectify it? Have you contacted the Support team about this as well?

Accurately. A few days ago ronin-mx returned from service Dji in Germany. They calibrated it and centered in each axis. I ran it probably 3 times and after taking a calibration process started to happen the same things.

I have same problem, did you sloved this issue?

This is how it looks like. I have tried everything (update, calibrate and it is perfectly balanced)



DJI What is wrong!