EdisonW1979
Second Officer
Flight distance : 1535679 ft
Canada
Offline
|
FlyingUser Posted at 2018-9-16 07:28
Unlikely, you won't get Moiré patterns with bad focusing.BTW, line skipping is still quite common, unfortunately. Full-sensor readout and smart downsizing to 4k needs quite significant processing power and proper cooling of the image processor. Where is the image processor located for the m2p and the p4p? (camera head right behind the sensor vs in the aircraft?)
I must disagree...
Whilst yes I can identify Moire patterns in the footage in question of the M2P, pay close attention to the King card on the left side; that doesn’t show Moire distortion, but is rather completely out of focus. I’ve seen how some sensors, especially Sony’s, which the M2P uses, can create Moire-like distortions in out-of-focus scenarios, or at certain ISO levels.
As for where the actual ISP is for the camera, there’s no way to know for sure, as no schematics have been made available, and I don’t recall seeing the ISP on the tear down image of the M2P that was posted here for a while. I would like to think this chip, which likely generates a lot of heat, is located somewhere in the main chassis to allow the primary cooling system to govern its temperature.
I guess the bottom line is, we can’t know anything for certain at this point, at least, not with this video and how the guy presented it.
I went onto DPREVIEW.COM, and they state they’ll be doing an in-depth review of the M2P/Z, so it’ll be interesting to see what they come up with, as they are VERY good in doing these analysis’.
Until then, most of this is idle speculation... |
|