1nagofly
lvl.1
Malaysia
Offline
|
fans537ac95a Posted at 11-15 01:40
I'm not sure if this is an isolated case, but after upgrading the firmware, my camera tends to freeze.
More specifically, it doesn't happen every time, but when I rotate the screen and the DJI logo appears (indicating a cold boot), the roll axis gets stuck and after a few seconds, it automatically enters gimbal protection mode.
However, if the DJI logo doesn't appear upon startup (meaning when it's quickly turned off and then on again within a short period), there are no issues.
I have exactly the same issue after firmware upgrade!!
and I have sent a post here as well, not realizing that you have also highlighted. but mine is a bit different, it turned side way to the left, then got stuck there. then the gimbal protection prompt appears.
but I am glad I am not alone. At least it shows that my gimbal is alright, and it is all pointing to the firmware update. |
|