ivanmini
lvl.1
Flight distance : 183983 ft
Brazil
Offline
|
English:
Hello everyone, I'd like to inform you that I was the one who initiated the topic and I was very disappointed with the brand for stating that the issue was with the smartphone. Likely, this response was given by someone lacking technical knowledge for the job.
As we've seen in some responses from Mini 2 owners who faced the same issue, this happens due to overheating in the 5.8GHz chip during the update process, causing damage to it. The brand should have included in the manual that the drone must be placed in a well-ventilated environment during the update process to prevent this problem.
Moreover, overheating in these models doesn't just occur during the update process but also when simply pairing with the remote control on the 5.8GHz frequency while the drone is not yet airborne.
As observed, the problem is resolved by replacing the chip (which should be done by an electronics technician). However, the cost of replacement is high compared to the drone's value; perhaps it's not worthwhile to make this substitution and continue flying solely on the 2.4GHz band until the drone's end of life.
Nevertheless, this is a risky flight operation since if the drone loses the 2.4GHz signal, it automatically attempts to reconnect on the 5GHz frequency. I don't recommend using the drone in high-risk areas for accidents, such as during long flights or in enclosed spaces.
The issue occurs with DJI Mini 1, 2, and 3, as I've read in other threads.
Portuguese:
Olá pessoal, gostaria de dizê-los que fui criador do tópico e fiquei muito desapontado com a marca por relatar que o problema era no smarphone. Provavelmente essa resposta foi dada por pessoa sem conhecimento técnico para a função.
Como vimos em algumas respostas de donos do mini 2 que tiveram o mesmo problema, isso ocorre devido à um superaquecimento no chip 5.8GHz no processo de atualização, danificando-o. A marca deveria ter colocado no manual que o drone deve ser dolocado em uma ambiente de ventilação forçada no processo de atualização para evitar esse problema.
Além disso, o superquecimento nesses modelos ocorrem não somente no processo de atualização, mas também no simples processo de parear com o controle remoto na frequência de 5.8GHz enquanto o drone ainda não está voando.
Como vimos também, o problema é solucionado substituindo o chip (que deve ser feito por um técnico em eletoônica). No entando, o custo da substituição é alto em comparação ao valor do drone, talvez não compense fazer essa substituição e continuar voando somente na bando 2.4GHz até o fim da vida útil do drone.
No entanto, isso é uma operação de voo arriscado, uma vez que se o drone perde o sinal 2.4GHz ele tenta se reconectar na frequência 5GHz automaticamente. Não recomendo que usem o drone em área de risco de acidentes. como em voos longos ou em áreas fechadas.
O problema acontece com Dji Mini 1, 2 e 3 conforme outro tópicos que eu li. |
|