DJI Paladin
Administrator
Offline
|
Hi there. Thank you for reaching out and we do apologize for the trouble. Please download the DJI Assistant 2 software on your computer using the link below and please update/refresh the firmware of both aircraft and controller. After that, try to link them again using the combination buttons to further isolate the issue:
DJI Assistant 2 software: https://www.dji.com/downloads/so ... sumer-drones-series
Using Button Combinations
1. Power on the aircraft and the remote controller.
2. Press the C1, C2, and Record buttons simultaneously until the status LED blinks blue and the remote controller beeps.
3. Press and hold the power button of the aircraft for more than four seconds. The aircraft beeps twice after a short beep, and its battery-level LEDs blink in sequence to indicate it is ready to link. The remote controller will beep twice, and its status LED will turn solid green to indicate linking is successful.
Notes:
• Make sure the remote controller is within 0.5 m of the aircraft during linking.
• The remote controller will automatically unlink from an aircraft if a new remote controller is linked to the same aircraft.
• Turn off the Bluetooth and Wi-Fi of the remote controller for optimal video transmission. |
|