DJI Gamora
Administrator
Offline
|
Dpederson Posted at 4-12 11:38
I just did the firmware update on my Air 2S and my controller is dead to the world. It was fully charged when I did the update. Please help I have a photo shoot tomorrow. RC231 controller
Hi, Dpederson. Thank you for reaching out and we're sorry to read about this. Please try the recommended troubleshooting steps below:
1. Please power on the remote. The power-on method: Press the Power Button for one second, then again, hold it to power the remote controller on.
2. Please press the power button once to check if the battery level LEDs are light on. If not, please use the official charger to charge the remote controller.
3. If the battery level LEDs are light on, please try to connect the charger, then power on the remote controller to see if it is normal, if not, please send back the remote controller.
4. Check whether the operating temperature is within the normal range (-10° to 40° C (14° to 104° F).
Hope this helps. Please keep us posted. |
|