UAVInternationa
lvl.1
Netherlands
Offline
|
Adela,
I now see that your message was 11 hours ago, so there is some time-difference....
The sound the RPA makes during attempt to update and when it is actived with the RC is the same: Biep-Biep-Biep.....
Story:
- after receiving the Matrice last week, I assembled it without a gimbal (gimbalset 2 was not delivered yet). After activating the system (RC + RPA + DJI GO app), the LED was flashing yellow and in the GO-app was a message to update the software.
- first I updated the RC with the DJI GO-app: succesful.
- not having a gimbalconnection, I downloaded the DJI Assistent 2. Connected my PC with the RPA and started up the RPA. Immediately the available softwareversions were displayed and I selected the latest version (v1.3.1.00 dated 2016.04.13). After this the update was in progress. Reaching the 100% the message was displayed: update failed, 0c00 Esc(0) device is not connected! Note: Restart the device before updating the firmware.
- starting up the system there was no flashing LED at all and beeps coming from different sides of the RPA. No connection to the RC.
- after receiving the gimbalkit and the gimbal (Zenmuse X3) I updated the RPA with the softwareversion on the site: Firmware update package (Zenmuse X3) v1.3.1.00.
- after more than 1 hour, no indication beep that the software was succesfully updated, I stopped the proces. The file in the sd-card had the message:
========= 2016.06.18 16:00:04 =====================
Packet: MATRICE100_FW_V01.03.01.00.bin
Result: Failed.
Reboot the aircraft and try to upgrade t-he firmware again.
- several attemps, no succes, but the LED was now active (red), the RPA beeps, and I could connect the RC again.
- message on the DJI Go app in Overall status: MC connection to center board failed. Restart aircraft. Contact ....
- update again: 3 messages in Overall status: Aircraft update error. Retry with proper upgrade steps. ESC Status error.
- update again: 1 message: ESC Status eeror.
- trying to start the Matrice (automatic take of and start): message is shown: ESC Status Error . Turn off etc
I've checked, rechecked and double-checked all connections on the main-board of the flightcontroller: everything seems to be connected.
Enough information I hope?
Koos |
|