perdidoflyer
lvl.2
United States
Offline
|
Guy - I agree, and IMHO, DJI really needs to address the wiring to the ESC's...it should be a plug connection on both ends of the ESC. The solder points are very close together, and it takes a fair amount of skill not to apply too much heat to the ESC, or to leave a stray piece of solder between two of the points. This would be especially helpful with the problems with the V3's and confusion around the ESC's, as well as those that have sought to upgrade to the new motors/ESC's used in the V3's. As an alternate, DJI should offer motors and ESC's in matched and pre-soldered sets. Again, MHO. |
|