What vibration isolation balls are you using. We are currently getting good results on the firm white balls. You don't say what craft you are flying the H3-3D on. Have you balanced the props, motors etc. Vibration on the craft can translate down to the gimbal.
Tahoe_Ed Posted at 2014-11-4 20:36
What vibration isolation balls are you using. We are currently getting good results on the firm whi ...
Hello,
we are using white balls from the box, we got the Phantom 2 recently. The props are the new ones, we changed them, but it gave no results. The motor is not balanced, but I should notice that the Phanton without props is not buzzing around the table, like it was described in following video (2 min 10 sec)
Please set your gains at the default values for the Phantom 2. Are you using the retaining clips? If so are they only attached to the first click not the second one which compresses the ball and causes vibration.
Hello
After update Zenmuse H3-3D from 1.0.0.4 to 1.0.0.10 I have vibration problem! http://youtu.be/S4UJfgh2670
The problem arises in flight mode. Video taken in no wind days. At the end of a fragment of a video shot before the upgrade gimbal (old version 1.0.0.4 was from the factory) After the update version is 1.0.0.10.
Before the flight, I produce Additional IMU calibration and Basic calibration of the gimbal through the Phantom 2 Assistant 3.4 software. What do I do now? I have a defective shoot ((( Please help!
Hi friends! I solved the problem of vibration Zenmuse H3-3D gimbal. Instal Anti Interference Board for Zenmuse H3-3D into Phantom 2.
See video http://youtu.be/RzBQS3tEqJE