Charging Hub and Power Bank

Swedrone

Anyone got a third party powerbank to work with the Avata 2 Charging Hub?
When I connect my 20000 mAh with USB-C with PD 3.0 and rated 65 W the charging hub starts charging the powerbank

Works however when connecting with the USB-A port from the powerbank but would take around 4 hours for a charge instead of 30 minutes with fast charging (20-80%)
Thia could perhaps be by design to get you to buy the car chager or the DJI Power.
Any ideas how to get a workaround here would be very appreciated

djiuser_3aCG77NbJVg7

I use the "Addtop D65" Powerbank from Amazon, which works correctly with the Avata 2 charging dock ;-) It also has 20,000mAh batteries and is surprisingly cheap. It might get a little warm at 65 watts of output power, but it works absolutely flawlessly

Funn 1

I have the Anker 548, it does have 1 Usb-c out (60w) and one Usb- (in-out) Use the Out to charge the flight packs and the in-out to charge goggles and RC/MC

https://www.amazon.com/Anker-Pow ... 50&gad_source=1

BobWinNV

The USB A port might not deliver full power from your charger. Check the specs on the charger.

Swedrone

djiuser_3aCG77NbJVg7 Posted at 5-18 07:21
I use the "Addtop D65" Powerbank from Amazon, which works correctly with the Avata 2 charging dock ;-) It also has 20,000mAh batteries and is surprisingly cheap. It might get a little warm at 65 watts of output power, but it works absolutely flawlessly

Thanks for the tip, just ordered it and will update with my results later this week. Danke