Boah99
lvl.3
Flight distance : 13819 ft
United States
Offline
|
fans40bb6bd3 Posted at 2017-8-13 02:51
Thank you for the reference
But I think it should say
1. 2 (clicks) same time because the time between the first one and the second one should be indicated as if it is too long you have to do it over again.
I am new to the world of drones so when I ordered my spark I read everything I could find on the DJI site including the FAQs. I agree that this should be in the manual, but the FAQs does have this section:
6. What functions can the power button perform?
- Turning the battery on and off: Press the power button once, and then press again and hold it down for at least two seconds to turn the battery on or off.
- Checking the current battery level: Press the power button once to check the current battery level.
- Linking Spark and the remote controller: Hold down on Spark’s power button for three seconds, and release on hearing a beep. Spark’s front indicators will start to flash in red, signifying Spark and the remote controller have been linked.
- Delinking Spark and the remote controller: In order to use your mobile device to control Spark, you will need to delink the aircraft and remote controller. Power on Spark, and hold down on Spark’s power button for six seconds until you hear it beep twice. Now Spark and the remote controller have successfully been delinked and you can search for Spark’s Wi-Fi on your mobile device.
- Resetting Spark’s Wi-Fi username and password: Hold down on the power button for nine seconds, and release after hearing it beep three times. Your Wi-Fi settings will be reset to the factory default.
- PalmLaunch: Power on Spark and place it on your palm with the camera facing you. Make sure your fingers are lower than Spark’s arms. Press the power button twice when the flight indicators start to flash green. The indicators will change to a slowly flashing yellow, and FaceAware will begin to recognize your face. The front indicators will turn to green if detection is successful, and PalmLaunch will be activated. If not, the indicators will flash red. |
|