Punchbuggy
Captain
Flight distance : 483166 ft
Australia
Offline
|
fansa7dc5944 Posted at 2017-7-6 21:02
According to "Release Note", you MUST update the RC first. And if you use Dji Go 4 for the update process then UPDATE Dji Go 4 first. This update requires Dji Go 4 version 4.1.x to work.
FYI, when the Aircraft update progress to 84%, it will stay there for quite long, just wait 5 to 10 minutes.
No it doesn't - see Notes below. It only hints that if you're upgrading both via DJI GO, you upgrade the P4 'after restarting the updated controller'. I Never update any of my craft using other than Assistant 2.
Notes
• Make sure you restart both the aircraft and remote controller after updating them to the latest firmware. Otherwise, video downlink may be unstable. Re-link the aircraft with the remote controller if they are disconnected.
• If you are updating via DJI GO 4, make sure you update the aircraft but only after restarting the updated remote controller. Otherwise, there will be an error in the progress bar of the aircraft update.
• Please note that firmware update may reset various Main Controller Settings, such as the RTH Altitude and Maximum Flight Distance, to factory defaults. Before the update, take note of your preferred DJI GO settings, and readjust them after the update to suit your preference.
• Requires the DJI GO 4 app v4.1.0 or later, otherwise the flight will be restricted to a height of 30 m and distance of 50 m. |
|