dr.nick
lvl.2
United States
Offline
|
Propwash Posted at 2017-7-13 02:08
Using the dji osmo 37mm adapter converts the osmo's lens thread to a true 37mm thread,allowing more choice of lens accessories a useful piece of kit.
Thanks Propwash. Was looking for a snap-on hood but open to the idea of screw on. I assume the DJI adapter just reverses the 37mm thread from OD to ID. Do you know of any hood that would screw into that setup that doesn't vignette? 22mm is a fairly wide angle and most wide angle hoods I'm aware of cut the corners out to avoid vignetting. I assume any screw in setup would be round rather than have corners cut out? Otherwise, it'd have to have the screw threads perfectly calibrated so the cutout corners line up properly when screwed all the way in. |
|