ZSAY
lvl.1
Flight distance : 7785 ft
Saudi Arabia
Offline
|
ImHereToCrash Posted at 2017-8-7 20:05
there is a delay between when phone/tablet will sync to RC via OTG.. i usually pair my spark to RC first.. then i connect my ipad turn off wifi on ipad, and BT... i say wait 30 seconds from sync time till plugging -in in total after syncing RC to spark.. as for direction, RC is the host, so OTG must be RC side.. as for which to plug in first, it's just a cable being repinned mostly so doesn't matter which side goes in first as long as host is RC side..
as for shortened range on 2.4Ghz or 5.8Ghz i have seen both scenarios..depends on location, enviroment and if nature is against you. if you dont want to fuss around trying to pick the best signal, then once everything is synced up with OTG and wifi and bluetooth is on on the tablet/phone, hold button on back of the spark (on the battery) till it beeps once, let go it should change flashing patterns its now hunting for new signals, on the RC press Pause + FN + C1 and hold it for a couple of seconds after starts rapidly beeping at you (2-3 seconds AFTER it begins beeping rapidly at you), then let it go.. the RC will beep rapidly until the two reconnect on the "best" signal then in the app you should see a clear picture with little to no lag. if bad quality or laggy (like half second or more) redo linking process again.
Hi ImHereToCrash, you state in your first paragraph "turn OFF Wifi on iPad and BT."
But then you state later in second paragraph "then once everything is synced up with OTG and wifi and bluetooth is ON on the tablet/phone, hold button on back of the spark,,,,"
I'm confused, you turn back ON Wifi and BT again?? |
|