Hi,

I would like to make my Matrice 100 equipped with the following
- Dual Batteries
- Z30 Gimbal and Camera
- Guidance System

The parts i have are
- 2 batteries compartment
- 2 expansion bays

Am I right to say that from what I have I can only come out with the following setup  ?
- Single battery + Guidance system + Z30 Gimbal and Camera

Reasons:
1) Because the guidance core battery will need to be connected to the XT60 port on the DJI Matrice
2) I can only mount the guidance system bove the center frm, if not it will obstruct the Z30 GImbal
(Note: check the attached pictures out)

If so, can i stack 2 battery compartments & 1 expansion on top of the frame so that I am able to mount the guidance system  ? (As the guidance system need to be mounted at least 8 cm above the center frame.

Anticipate for any help from you guys.

Thank you

Aloha jennifer,

     I hope you found out you could mount two battery bays and Guidance.  My friend and I recently just got it up and running with that configuration.

Aloha and Drone On!

Hi,

Do you yet own Z30 gimbal? Is yes, do you see a strong drift (stabilisation issue) even from ground?
If not, be careful, at the moment, many M210's users can t use their Z30  because of drift issue !
Maybe that will work well with Matrice 100.... could you confirm?

thanks

hi jenniferliupl,
I'm facing the same situation as well, i think you might need 3 expansion bays in order to put dual battery, camera gimbals and guidance system all together.