After not usin my P3P for some time (As I was flying my spark recently) I tried to use it today. DJI go asked for update both for RC and craft as well. I uodated my TC well no prob. But when it comes to update my p3p I see its not doing it.i downloaded latest firmware ( P3X_FW_V01.11.0020.bin) copied to sd card as i did before/But when I insert the card in gimble and turn on P3P a red light starts to blink without any beep and its not updating. Normally red and green should blink one after the other.But its not doing it. Why is this happening I dont know. I had updated it before this way and now its not updating. What could be the reason ?

Wrong forum.This for Standard

Did you format your sd card before beginning the update?

ALABAMA Posted at 2017-8-28 16:27
Did you format your sd card before beginning the update?

I did .But may be format was wrong. I used another SD card and its updated. This time Rc is not connected to aircraft. I am trying to resolve that too.

bener Posted at 2017-8-28 20:19
I did .But may be format was wrong. I used another SD card and its updated. This time Rc is not connected to aircraft. I am trying to resolve that too.

might try just to relink them

Did you format the card in PC card slot or in copters cam? If it was in a PC card slot then the copter may prompt up "invalid SD card".

Has the issue been figured or not? Please contact us if there is any further questions.

DJI Susan Posted at 2017-8-30 01:15
Has the issue been figured or not? Please contact us if there is any further questions.

Thanks for your interest. Issue is resolved. I managed to connect RC to AC. Now Only issue is max distance issue.I can't make it more than 500 m. so Aircraft max.distance capacity is no use then. Even I buy an inspire 2 it means again ı will be limited with 500 m. with these updates.

bener Posted at 2017-8-30 22:31
Thanks for your interest. Issue is resolved. I managed to connect RC to AC. Now Only issue is max distance issue.I can't make it more than 500 m. so Aircraft max.distance capacity is no use then. Even I buy an inspire 2 it means again ı will be limited with 500 m. with these updates.

Thanks for keeping us updated. As for the max distance, please make sure the Distance Limit has been disabled and adjust the antenna to confirm the performance.

DJI Susan Posted at 2017-9-2 00:21
Thanks for keeping us updated. As for the max distance, please make sure the Distance Limit has been disabled and adjust the antenna to confirm the performance.

OK thanks. I will try to do it