Hi
I try to controll on some servo with the extened kit of the remote controll lb2 with no success on the matric 600.
I maped the ports to the switchs on the dji assistent 2, but still nothing happend
I try to switch ports , and also gave to the servo 5v separately.
Any idea ?

How do you wire the servo to lb2? You must use Minus and Signal from the LB port to the servo and supply the servo with Minus and Plus voltage from an external power source

nil Posted at 2017-9-4 01:20
How do you wire the servo to lb2? You must use Minus and Signal from the LB port to the servo and supply the servo with Minus and Plus voltage from an external power source

yea !!! it works.
Thanxs.

nil Posted at 2017-9-4 01:20
How do you wire the servo to lb2? You must use Minus and Signal from the LB port to the servo and supply the servo with Minus and Plus voltage from an external power source

Hej nil,

I'm planning to control my 3rd-party-gimbal on a M600 with the channel expansion-kit. Is it possible without any onboard or mobile SDK to set the channels on the A3 pwm-output?

Mvh