Good day all,

  

  

I often use my Inspire 2 for mapping missions on GS PRO and usually use the function 'Capture at equal distance' for 3D mapping.

  

  

However I was required to use my Inspire 1 for a mission, and it appears that this mode is not available for the Inspire 1, even though it appears I have the latest firmware update and GS PRO app.

  

  

Am I missing something here? furthermore I believe it has been possible to use this mode in the past on an Inspire 1.....

  

  

I have cross checked that everything is up to date, but still no luck.

  

  

Any information or suggestions would be appreciated.

  

  

Thanks in advance.

Hi, can you review the manual and make sure you are setting up the GS Pro properly? https://dl.djicdn.com/downloads/ ... _Manual_EN_V1.8.pdf

And could you please provide us a screenshot of this? I'd like to check. Thanks.

DJI Thor Posted at 2017-9-17 23:03
And could you please provide us a screenshot of this? I'd like to check. Thanks.

Hi DJI Thor,

I have been through the manaul still no luck. Please see the screen shot below.

Desert Drone Pi Posted at 2017-9-26 23:15
Hi DJI Thor,

I have been through the manaul still no luck. Please see the screen shot below.

Hi there, I am so sorry to tell that I was confirmed that Inspire 1 doesn't support capture at equal distance interval, in fact, drones that were published after Phantom 4 will support this function, but you can still choose equal time interval.

HI

I'am having the same problem with my Inspire 1 V.2 - This one should support the function.