Dear gurus.
I am developing custom drone with A3 + Lightbridge with OnBoardSDK 3.3.1
I plugged my custom board to A3 API port with UART interface.
All activation and controll is good with simulator.
But after adjusting yaw value, the simulator drone moves different direction.
I didn't take-off real drone in the air and sorry for this because I don't have profellers yet.
Do you have any idea about this?
Is just problem with simulator?

Regards.

A simulator drone is a much different prospect then what is used for. Usually answers on that can be found through the product page. Why not look in the software configuration to see if you can get an answer there on this page? http://www.dji.com/support/product/a3