Hey..

Since I got my inspire 1 PRO i cant ballance my props...  you know...  the PRO props has a oval hole, and I cant find anything fit it

What to do ??

Regards

Lars

This: https://www.amazon.com/EJH-Preci ... spire/dp/B01AOHVRGE  

and this: https://www.amazon.com/Dubro-Pro ... words=prop+balancer

unfortently not to the PRO propelles  but the props with round hole...   the PRO props has oval holes

Do nothing, you'll fly just fine. No need to balance genuine DJI props ...

It seems you purchased wrong propellers, please provide pictures of propeller and propeller mounting plate for further assistance, thanks.

Hmm, no ....  its the normal quick release props = standard on the inspire 1 pro

LarsPlovmann Posted at 2017-9-27 23:35
Hmm, no ....  its the normal quick release props = standard on the inspire 1 pro

Hi Lars,

Does the I1 pro have different props to the I1 now?

Mark G.

LarsPlovmann Posted at 2017-9-27 23:35
Hmm, no ....  its the normal quick release props = standard on the inspire 1 pro

Well I think I misunderstood your post, can you please show us the picture of the drone with propellers from the front, we will see if the propellers are normal.

Yes okay...   but there is only one  quick realese kind     but here is pics...

and one more

LarsPlovmann Posted at 2017-9-28 01:04
and one more

I don't see any problems

problem ??    I ask  if someone know  how to ballancing  those kind of Props     I cant find anything fit in to the oval hole in the propel so I can ballanced them...

Do you understand ?

LarsPlovmann Posted at 2017-9-28 03:54
problem ??    I ask  if someone know  how to ballancing  those kind of Props     I cant find anything fit in to the oval hole in the propel so I can ballanced them...

Do you understand ?

They don't need balancing Lars, if they are genuine DJI props they should be good to go.

Mark G.

Amazon has one for the 1550 props which are quick connects and they say for the red and white marked ones.  Don't know if it fits the i1 with the newer QD props but it may.

https://www.amazon.com/EJH-Preci ... ancer+DJI+Inspire+2

Fwiw, I made one out of 10" drill rod and small wooden rectangular blocks (To fit into the props and 90 degrees to each other.) at each end and statically balanced that shaft.  Then pressed it into the I2 props.  A couple were off out of the 8 I have, but not bad overall given their length.  You can rotate them on the shaft 180 degrees and see if they verify if in doubt.  Old RC guys have done that long before DuBro came out with their prop balancer which I also have from the RC planes and use with the above.

No Mark...  they are not ballanced  desend ....  I will still ballanced my props like I always done,  and hope its okay for you   

LarsPlovmann Posted at 2017-9-28 07:04
No Mark...  they are not ballanced  desend ....  I will still ballanced my props like I always done,  and hope its okay for you

Fine by me, do what you want matey.

   just Kidding Mark, Hope you can take it

LarsPlovmann Posted at 2017-9-28 08:33
just Kidding Mark, Hope you can take it

I can take it Lars Good luck with your ballancering.

Mark G.