mmaler
New
United States
Offline
|
I have spent days trying to figure out this issue and hoping that someone here could help me out.
After a light crash, the gimbal ribbon snapped. I replaced the ribbon, verified all connections several times but the gimbal continues to beep in three successions (beep, beep, beep, pause, beep, beep, beep, pause). Here are all the things that I have already done:
• Vertified all ribbon connections several times and have re-connected several times.
• Potentiometers calibrated and vertified no damage and correct ohm readings.
• Inspected all motors for damage or loose transistors.
• Firmware updated to latest versions (RC, FC, Zen, Etc).
• RC Calibartions from both RC and PT2.
• Camera light is green.
• Video and photos display.
Again, the camera light is green, video displays, but beeping will not stop and no control of the gimbal. Does anyone have any idea what the three beeps indicated. I have spent hours searching forums with no luck. Any help would be greatly appreciated!!
Thanks,
Mike
|
|