Hi All,
For the first time, I managed to try out gesture control on my spark, it all worked actually quite well (I didn't try the video side). However I've noticed that the photos are a little blurry, I took 4 different ones and everyone the quality is not great. If I take a picture wth the remote it's fine, just in gesture mode. It wasn't windy and the lighting was ok.

Any suggestions?

Thanks

Kevin

Can you show some examples?
Like from the same moment,  taken with remote AND with gesture control?

Kladhams, can you provide the pictures for us to check?

Thanks for your replies, I have been away so hadn't seen your messages until now. I will try and get a comparison within a few days to share.

DJI Elektra Posted at 2017-9-29 02:48
Kladhams, can you provide the pictures for us to check? Please notice that the resolution in gesture mode is 1440x1080 and the resolution in P mode is 3968x2976.

DJI Elektra Posted at 2017-9-29 02:48
Kladhams, can you provide the pictures for us to check? Please notice that the resolution in gesture mode is 1440x1080 and the resolution in P mode is 3968x2976.

Hi,I have attached 2 sample photos which were taken using gesture mode.

Vinoth Barathi Posted at 2017-10-9 20:06
Hi,I have attached 2 sample photos which were taken using gesture mode.

Did you try to connect your AC with RC and then use the gesture control to shoot a picture?  You can also change your camera setting for check.
Please ensure that there is sufficient light and less wind around your spark and have the test, if the picture is still blurry, please provide the origin picture. And the firmware of your drone, the version of your app.
Please keep us updated. Thanks.