toby
lvl.1
United States
Offline
|
I'm new to the forum and have searched for this topic. It's probably entirely my fault and hopefully I can get some help.
Recently I took a small tumble. Here is the back story that leads to my question.
A while back I took a tumble flying a stairway on a ski cabin. After that, the copter ocilated and didn't fly smooth. I found a local shop and they calibrated gyros using the Assistant Software. They said if I took a tumble, just cailbrate the copter using the software as long as its not a Gimball issue.
This time the tumble wasn't during flight.
Upon landing and not thinking the copter would increase power, I stepped away to relook at the intended flight path, and the copter powered up and tipped over. The tip over totalled two props, luckily I had spares learned from the previous tumble. The copter seems like its a bit out of balance again and I've headed the advise and wanting to connect to the Assistant Software.
However, after the researching the forum, I cannot find a thread on connecting the copter to the Assistant Software.
Can someone point me to a thread, a .pdf, or video that shows the process?
Thanks in advance for you help.
Sincerely,
Toby | Phantom 2 H3-3D & GoPro 4 Black | http://www.youtube.com/goingbigger
|
|