Hello Members,

I recently bought a zenmuse H3-3D for my F550. Then i installed it on my F550 en updated the software of the zenmuse.
When i power up my drone the gimbal goes grazy and does not stay still. I made a video of the problem and added a link.  



I hope someone can help me with my problem. Thanks!

Greetings Danny

Download The Zenmuse Assistant software and complete any firmware updates as well as calibration. If that does not work, a technician may be required to look at this. Also, review the manual and make sure you have set this up correctly: https://www.dji.com/zenmuse-h3-3d/download

DJI-Mark Posted at 2017-10-5 07:34
Download The Zenmuse Assistant software and complete any firmware updates as well as calibration. If that does not work, a technician may be required to look at this. Also, review the manual and make sure you have set this up correctly: https://www.dji.com/zenmuse-h3-3d/download

thanks for your reply. I am going to try it out

Danny79 Posted at 2017-10-9 12:50
thanks for your reply. I am going to try it out

Hello Mark,

I have updated the software through the assistant but still no change. I own another Gimbal that i used on my F450 with the same GCU that i now installed on my F550. Gimbal on the F450 worked perfectly. When i put the gimbal  of my F450 on the F550 with the GCU i get the same crazy rolls with noise.

i hope you can help me.

best regards,

Danny

Danny79 Posted at 2017-10-9 13:14
Hello Mark,

I have updated the software through the assistant but still no change. I own another Gimbal that i used on my F450 with the same GCU that i now installed on my F550. Gimbal on the F450 worked perfectly. When i put the gimbal  of my F450 on the F550 with the GCU i get the same crazy rolls with noise.

What type of gimbal on the 550?

DJI-Mark Posted at 2017-10-9 13:24
What type of gimbal on the 550?

Hello Mark,

I have 2 Zenmuse H3-3D Gimbals. One for the F450 and one for the F550. But i have only one GCU. I first installed the the GCU on the F450. But now i did installed it on the F550. Is it possible that the GCU in anyway causes this problem? It worked fine when i installed it on the F450.

best regards,

Danny.

Danny79 Posted at 2017-10-11 02:14
Hello Mark,

I have 2 Zenmuse H3-3D Gimbals. One for the F450 and one for the F550. But i have only one GCU. I first installed the the GCU on the F450. But now i did installed it on the F550. Is it possible that the GCU in anyway causes this problem? It worked fine when i installed it on the F450.

Reinstall the gimbal on to the 450. If it works, then that would be your issue.