Hello!

please look at my Video:

My new Hexa works fine: T14sg, A2, OSD MK II, DJI Zenmuse H4-3D (GCU V2 1.12, IMU 1.12 (Assistent 1.4.2 = 1.13???)

Only in curves the Zenmuse hangs on one site (outside the curve). When I fly straightforward the horizon get even...

All Firmware is uptodate - only the IMU Shows not the V1.13...

What is wrong?

Thanks you for help.

Holger

I suspect its an IMU attitude correction problem. Try IMU calibration, if not help, it might be gimble hardware failure.