edith Posted at 2017-10-31 04:27
Now i have the version BETA 600

I have already updated, is it necessary to update the RC with the same version?

Can I also get a copy of the beta firmware

edith Posted at 2017-10-31 04:27
Now i have the version BETA 600

I have already updated, is it necessary to update the RC with the same version?

The RC should be at V1.9.3. If not you could update as follows :-

With RC and display connected (aircraft off), and display has a good wifi connection to internet. Run DJI Go 4 and 'enter device'. Open the 'aircraft status' screen by tapping the screen at top edge where it says 'disconnected'. The top line 'Overall Status' should show if update required (this may take a few seconds to appear). If it does then tap on that and it should take you through the process to update RC.

Aardvark Posted at 2017-10-31 05:06
The RC should be at V1.9.3. If not you could update as follows :-

With RC and display connected (aircraft off), and display has a good wifi connection to internet. Run DJI Go 4 and 'enter device'. Open the 'aircraft status' screen by tapping the screen at top edge where it says 'disconnected'. The top line 'Overall Status' should show if update required (this may take a few seconds to appear). If it does then tap on that and it should take you through the process to update RC.

Thanks for always helping people on the forum Aardvark.

Another thread said they're almost complete with testing and hopefully we see a official firmware update soon!

(I've been flying the last couple weeks, no issues that I experienced before came back)
I did notice that when I change color profiles, sometimes it will not show the right color profile until I switch from video to photo and then back. Or I would have to record then stop recording. In a way, it "refreshes" the camera settings.

Just adding my experience with the .600 beta.

Tried it today and the p4 flew great, steady as a rock and has lost the weird motor sound.
Flew it across the field I always use for testing and the very poor signal to my iPad mini2 also seems to be fixed.
I only flew it 500M but since the 'bad' update it would struggle at 100M.
NOT FIXED is the active modes issue I had before.
If I activate ANY of the modes the iPad screen instantly goes green/black and image breaks up.
No matter how near or far the P4 is, its the same.
As soon as I deactivate the mode the screen instantly fixes to good connection.
I have tried reconnecting the RC again but no difference.

So for me, Beta .600 is a Curate's egg   

edith Posted at 2017-10-31 04:27
Now i have the version BETA 600

I have already updated, is it necessary to update the RC with the same version?

Nope, only the drone, this is a drone firmware, not an RC firmware.

fansbb9ac8d7 Posted at 2017-10-31 04:50
Can I also get a copy of the beta firmware

Provide me with your DJI Account email, I'll add it to your account.

I have Phantom 4 and latest firmware is not good. Can you add me to BETA tester?
rcondajavier@gmail.com
Thanks Javier

I have Phantom 4 and latest firmware is not google.Can you add me to BETA tester?
mariolino123@hotmail.com
Thanks

javibelen Posted at 2017-11-2 08:40
I have Phantom 4 and latest firmware is not good. Can you add me to BETA tester?

Thanks Javier

Could you be more specific of your main issue? The beta is trying to fix the gimbal and wobble issue. More details, please check this post: https://forum.dji.com/thread-103711-39-1.html Please confirm if you have the similar issue, I'd like to help you to have a try.

fans29ff2d1d Posted at 2017-11-2 15:04
I have Phantom 4 and latest firmware is not google.Can you add me to BETA tester?
mariolino123@hotmail.com
Thanks

Please refer my reply in 90# and double check, thanks for your cooperation.

DJI Susan Posted at 2017-11-2 19:38
Could you be more specific of your main issue? The beta is trying to fix the gimbal and wobble issue. More details, please check this post: https://forum.dji.com/thread-103711-39-1.html Please confirm if you have the similar issue, I'd like to help you to have a try.

Since the last update I notice the phantom 4 more nervous. and when I shoot at 4k the camera reboots.
I have read that these problems are solved with the Beta update.
That's why I decided to try it.
I leave my email
rcondajavier@gmail.com
Thank you
Javier

I have Phantom 4 and latest firmware is not good.Can you add me to BETA tester?
mariolino12346@gmail.com
Thanks Mario

And when l shoot at 4k the camera reboots.

mariolino123@hotmail.com

Thank you DJI Diana for getting me into BETA!  It flew SAFE afterward. (2016 first batch P4) Did not test anything else.

DJI Susan Posted at 2017-11-2 19:39
Please refer my reply in 90# and double check, thanks for your cooperation.

90#
http://90 #

DJI Susan Posted at 2017-11-2 19:39
Please refer my reply in 90# and double check, thanks for your cooperation.

90#
http://90 #

DJI Susan Posted at 2017-11-2 19:39
Please refer my reply in 90# and double check, thanks for your cooperation.

http://I have Phantom 4 and latest firmware is not good.Can you add me to BETA tester? mariolino123@hotmail.com  Thanks Mario

DJI Susan Posted at 2017-11-2 19:38
Could you be more specific of your main issue? The beta is trying to fix the gimbal and wobble issue. More details, please check this post: https://forum.dji.com/thread-103711-39-1.html Please confirm if you have the similar issue, I'd like to help you to have a try.

add me to beta firmware, my email is eddyc@singnet.com.sg

add me to beta 1999fxd@gmail.com Thankyou

DJI Diana Posted at 2017-10-16 20:27
Got your account email, will add the beta firmware to your account within today, please try to upgrade it later.

Wobble/shaking problem was practically resolved by the 600 beta FW. Thanks Diana.

I have also had good results with beta 600, the instability problem is almost gone. When I’m desending it  shakes a bit.Only two flights. It seems to be slow in flight.

fanscf5de830 Posted at 2017-11-5 10:39
I have also had good results with beta 600, the instability problem is almost gone. When I’m desending it  shakes a bit.Only two flights. It seems to be slow in flight.

Can you add me to the beta list lennytodd2@gmail.com. thanks

fansbb9ac8d7 Posted at 2017-11-5 11:01
Can you add me to the beta list lennytodd2@gmail.com. thanks

PM DJI Susan she will help you. 90#

Tell me what it means 90 # Thank you.

DJI Diana Posted at 2017-11-1 22:19
Provide me with your DJI Account email, I'll add it to your account.

Lennytodd2 @gmail.com. thanks

fans29ff2d1d Posted at 2017-11-6 01:51
Tell me what it means 90 # Thank you.

Post #90 .its DJI Susan.Just scroll up.You need to send her a private message and she will add you to the beta version. It will show up in assistants 2 software.

I am experiencing the flight issues everyone else is having with FW 106.......may I get the beta 600 pushed to me as well?

thanks
markelliott1969@gmail.com

DJI Susan Posted at 2017-11-2 19:38
Could you be more specific of your main issue? The beta is trying to fix the gimbal and wobble issue. More details, please check this post: https://forum.dji.com/thread-103711-39-1.html Please confirm if you have the similar issue, I'd like to help you to have a try.

I need the beta as I am also experiencing all the issues these other people are.

thanks!

markelliott1969@gmail.com

javibelen Posted at 2017-11-3 07:15
Since the last update I notice the phantom 4 more nervous. and when I shoot at 4k the camera reboots.
I have read that these problems are solved with the Beta update.
That's why I decided to try it.

Thanks for clarification. I have forwarded this to the designated team to add you in.

fans29ff2d1d Posted at 2017-11-3 14:22
I have Phantom 4 and latest firmware is not good.Can you add me to BETA tester?
mariolino12346@gmail.com
Thanks Mario

Sir, your message has been well received. Please try to refresh the firmware when you received it.

fanscf5de830 Posted at 2017-11-5 10:39
I have also had good results with beta 600, the instability problem is almost gone. When I’m desending it  shakes a bit.Only two flights. It seems to be slow in flight.

Thanks for your feedback. If the drone still shake during the later test, please kindly export the flight data in the aircraft for further analysis. Appreciate your time and cooperation.

The messages above have been received. Please try to refresh the firmware when you received it. Appreciate your feedback.

Grazie Susan

When new firmware?????

fans8d977f77 Posted at 2017-11-7 06:22
When new firmware?????

Be patient, we've all waiting for it

My email: pinkypuff07@hotmail.com

I got happen 4k 30fps video suddenly stop and reboot like that.

Hi DJI Susan, can you add me to the beta?

brunobaptista555@icloud.com

Many thanks.

I would really love to get added to this Beta. I haven't been able to fly for awhile. Can anyone add me, please?